Black-dial Sinn 6060 steel head with odd-numbered 24-hour scale, outer 12-hour ring, date between four and five, and two crowns.
The 6060's additional left crown and shallower non-chronograph case guide the clearance check. Strap and loose bars are omitted.

Watch straps for Sinn 6060

This guide concerns the current regional black-dial 6060: a 38.5 mm steel watch, 12 mm thick, with an additional 24-hour hand and a rotating inner time-zone ring. It has two crowns and no chronograph pushers.

Reference
6060

Preserve the slimmer Frankfurt profile

Fine-grained black leather or a restrained brown finish can sit quietly beside the polished steel and grey ring. Compare a flatter end and modest taper to preserve the watch's relatively shallow profile.

Colour, construction and fit

Leave space around the left crown

A crown near ten operates the inner ring, with the main crown at three. Consider both sides when setting the strap's bend and worn position; bulky ends should not impede access.

Measure beyond the nominal 20 mm band

The regional page calls 20 mm the band width, not a verified physical gap. Measure the actual attachments, bars, end clearance and closure. Confirm length from the wrist and planned construction rather than diameter alone.

Questions about this reference

Is the 6060 interchangeable with the 6096?

No. The 6096 has a larger 41.5 mm case, a different profile and a 22 mm listed band width. Similar styling does not establish shared attachment geometry.

Is a particular 20 mm Da Luca strap approved?

No fit approval is supplied. The 20 mm source label is only a starting point for assessing the actual watch and intended ends.

Official Japanese regional Sinn 6060 specifications