Coloured ink illustration of the Panerai Luminor Luna Rossa PAM01653 head, with a grey dial, red small-seconds hand, steel case and right crown bridge.

Watch straps for Panerai Luminor Luna Rossa PAM01653

The Luminor Luna Rossa PAM01653 pairs a matte grey dial with a brushed steel cushion case and a small red seconds hand at nine. The white luminous numerals and right-side crown bridge keep the familiar Luminor identity clear. Its restrained head offers several colour directions beyond the original grey strap’s red accent.

Reference
PAM01653
OEM strap width (manufacturer)
24 mm

Read 24/22 mm as an original-equipment taper

Panerai specifies a 44 mm steel case and lists a grey Luna Rossa bi-material strap together with an additional black caoutchouc strap. Both carry a 24/22 mm taper description. Panerai’s sizing explanation identifies the first number as the strap’s case-end width and the second as its buckle-end width; the listed brushed steel buckle is 22 mm.

These are original strap and buckle measurements. The reviewed evidence does not separately establish the metal opening between the case lugs, so that measurement remains unknown here. A 24 mm factory strap end does not certify the shape, thickness or hardware of an aftermarket replacement.

Colour, construction and fit

Decide how much red to repeat

The red small-seconds hand is a compact accent against the grey dial. Charcoal or medium grey leather can keep it as the main colour detail; black creates a stronger outline around the steel head. A restrained warm brown offers a different contrast without attempting to imitate the original bi-material texture.

Red stitching can echo the seconds hand, but it introduces a longer, more visible line than the hand itself. Compare tonal and contrasting stitching beside the whole watch. The strap’s surface and seam should support the broad luminous markers rather than crowd them.

Balance the cushion case and crown bridge

A 44 mm Luminor head has a broad visual footprint. Compare a modestly padded centre with a flatter construction and inspect how each end bends near the case. The published diameter does not tell you the available clearance or the case’s overall thickness.

The crown-protecting bridge sits on the right. Keep the proposed strap ends and the watch’s position clear of that operating area. No particular quick-release mechanism or interchangeable attachment is established for a replacement by the evidence used here; inspect the actual watch and hardware before a build.

Specify the buckle and useful lengths together

The factory 22 mm buckle-end figure is only one part of a closure decision. If retaining that buckle, check its tang, pin arrangement, required strap thickness and end shape. Matching the stated width alone does not prove that it can be transferred to leather or another material.

Record wrist circumference and the lengths and hole positions of a strap you already find comfortable. Decide how much tail you want and where the buckle should sit before ordering a construction. Keep the original grey strap and additional rubber identified separately; shared taper numbers do not make their material behaviour identical.

Questions about this reference

Is 24 mm the confirmed case lug gap for PAM01653?

No. It is the documented case-end width of the original straps. A separate measurement of the metal case opening is not established here, and replacement attachment still requires inspection.

Does this guide certify a replacement for the factory 22 mm buckle?

No. Buckle width, tang and pin geometry, strap thickness and end construction must be checked together. The guide explains the original equipment and design choices without approving a Da Luca installation.

View Panerai’s specifications for PAM01653