Hamilton H69809730 black-PVD watch head with black date dial, subdued Arabic and inner 24-hour numerals, red seconds tip and right crown.
The 50 mm Mechanical head retains its date display and dark case. It is shown without the factory leather strap.

Watch straps for Hamilton Khaki Field Mechanical H69809730

The H69809730 takes the Khaki Field Mechanical to a 50 mm case. Hamilton specifies 12.55 mm thickness, a 24 mm lug width and the hand-wound H-50 movement. Its black PVD steel case surrounds a black date dial with subdued numerals and a red seconds tip. Those dimensions call for a fresh length and construction assessment rather than measurements borrowed from the familiar 38 mm Mechanical.

Reference
H69809730

Give the large black head a deliberate frame

The original black cow-leather strap keeps attention on the low-contrast dial. A matte black sample can continue that effect; a charcoal sample can separate the strap from the case. Check the visual weight of stitching and padding beside the actual 50 mm head before settling on either treatment.

Colour, construction and fit

Use 24 mm only in its published role

Hamilton labels 24 mm as lug width. It does not publish the inner seating, bar diameter or clearance under the bars here. Have the actual watch and proposed end examined together; nominal width alone does not establish a safe straight-end or pass-through attachment.

Plan length around this case

The 50 mm diameter describes the head, not the strap length required by your wrist. Compare the two pieces of a comfortable existing strap and the position of its buckle. A large head can change where the strap begins to curve; neither its span nor the needed padding can be calculated from diameter alone.

Keep winding and closure practical

Leave usable finger access to the right-side manual-winding crown. Hamilton identifies cow-leather strap H6006981001 and a pin buckle, but gives no buckle width in this listing. Measure that closure and assess its tang, bar and material allowance before planning reuse or taper.

Questions about this reference

Can I order from a 38 mm Mechanical guide?

No dimensions should be transferred. This reference publishes a 24 mm opening and a 50 mm case. Hardware, length and end clearance still require their own assessment.

Does 24 mm guarantee a Da Luca strap will fit?

No. It is the manufacturer’s nominal lug-width entry. The proposed end, bars, thickness and clearance must be assessed on the actual watch; no aftermarket fit is established here.

Official Hamilton H69809730 specifications