DOXA SUB 300 Carbon Professional 822.70.351.21 watch head with a mottled dark carbon cushion case, orange dial, broad black minute hand, date at three and white-and-orange dual-scale bezel; no strap or clasp.

Watch straps for DOXA SUB 300 Carbon Professional 822.70.351.21

The DOXA SUB 300 Carbon Professional 822.70.351.21 combines a vivid orange dial with a mottled forged-carbon cushion case and a dark dual-scale bezel. A titanium chamber houses the movement inside the carbon exterior. This is a different material and attachment context from a steel SUB 300. The selected reference comes on orange FKM rubber, so a replacement changes a large block of colour outside the already bright dial.

Reference
822.70.351.21
Manufacturer lug gap
20 mm

Decide whether the dial or the whole wrist should carry the orange

Black leather can isolate the orange face and continue the dark case, while charcoal introduces a gentler boundary beside the carbon pattern. A plain or fine-grained surface lets the mottled case texture remain visible. Orange stitching can echo the bezel markings without recreating the full orange factory strap, but compare its brightness and spacing at normal wrist distance. A coarse contrasting grain may compete with both the carbon and the two bezel scales.

Colour, construction and fit

Keep the 20 mm opening distinct from the cushion-case outline

DOXA lists the case outline as 42.50 × 45.00 mm, its height as 13.40 mm and the lug width separately as 20.00 mm. Those are different measurements. The opening does not prove that a generic 20 mm strap matches the original shaped ends. Inspect the fixing parts, end profile, thickness and clearance at the short lugs, then assess where the material begins to bend around the actual wrist.

Plan beyond the factory rubber and folding clasp

The orange FKM strap is paired with a black-PVD folding clasp and a ratcheting extension intended for a wetsuit. That assembly is not evidence that the clasp accepts an unrelated leather strap. Its required buckle-end width and connection need to be checked on the real parts. A replacement may use its own closure; decide that before taper, length and hole placement rather than treating the factory extension as a universal sizing device.

Use the correct Professional equipment context

The manufacturer also offers the same Professional head on black rubber as 822.70.351.20. That changes the supplied strap, not the orange dial or forged-carbon head described here. Compare those colour approaches without assuming that an accessory for a steel SUB 300 has the same connector. The watch's stated water resistance also does not establish the water suitability of a new leather strap or its closure.

Questions about this reference

Is the dark case simply a black-coated steel SUB 300?

The manufacturer identifies forged carbon around a titanium movement chamber and a titanium screw-down case back. The mottled exterior is part of this material identity. A black coating on a steel case would not represent the same reference or justify transferring its attachment assumptions.

Does the orange-rubber reference require an orange replacement?

No. Orange keeps the factory colour continuity, while black or charcoal concentrates attention on the dial. Colour choice remains separate from checking the 20 mm opening, end construction, fastening parts and the closure needed by the proposed replacement.

Official DOXA specifications for SUB 300 Carbon Professional 822.70.351.21