Watch straps for Blancpain Villeret Réveil GMT 6640 1127 55B
The Villeret Réveil GMT 6640 1127 55B brings an alarm, a second time zone and a date display to a white-dial steel watch. A blue serpentine hand reads against the 24-hour ring, while the alarm indications add another layer to the dial. Blancpain specifies a 40.30 mm diameter, 12.10 mm case thickness and 22.00 mm width between horns. Automatic calibre 1240H has a stated 45-hour power reserve. The original arrangement is alligator leather with a folding clasp; that closure deserves attention alongside the watch-end width.
- Reference
- 6640 1127 55B
- Manufacturer lug gap
- 22.00 mm
Balance a busy dial with a quiet surface
Black leather follows the source configuration and creates a clear border beneath the white dial. Charcoal softens that contrast, while a restrained dark blue can relate to the serpentine time-zone hand. Compare gloss as well as color: a strongly reflective surface or large pattern adds another layer beside the Roman figures, alarm display and 24-hour scale. Start with a calm texture, then judge how much stitching and padding the whole watch needs.
Colour, construction and fit
Leave room around the additional controls
The exact front shows two crowns on the right and a separate control at the lower left. A proposed strap end should be assessed with those controls and the adjacent case surfaces in view, including how the material moves when worn. Do not infer operating clearance from the 22 mm width alone. Keep the watch’s setting and alarm instructions separate from strap installation; this guide does not prescribe how to operate the controls.
Read the opening and profile together
The manufacturer’s 22.00 mm Width Between Horns is the opening at the watch, not a buckle measurement or a compatibility guarantee. Check the actual retaining hardware, end profile and material thickness before choosing a construction. The 12.10 mm case thickness gives another proportion to compare when considering padding and taper, but it does not prescribe strap thickness. Sharing an opening width with another Villeret does not establish shared attachment geometry.
Work out the folding-clasp arrangement early
Before specifying lengths, decide whether the original folding clasp is part of the enquiry. Its connection, inside width, permitted material thickness and closing arrangement need their own checks. Measure both pieces of a comfortable existing setup and record where the clasp sits under the wrist. Switching to a different closure can change the useful distribution of length, even when total strap length looks similar. Confirm that plan before treating color or grain as the final choice.
Questions about this reference
Is the blue serpentine hand a date pointer?
On this reference it belongs to the second-time-zone display and the 24-hour ring. The date appears in a window near six. Keep the Réveil GMT’s alarm and time-zone arrangement distinct from a pointer-calendar Villeret when identifying the watch.
Does the original folding clasp establish replacement compatibility?
No. Blancpain’s factory specification identifies the supplied closure. It does not approve another strap’s clasp connection, thickness or end construction. Provide the exact watch and clasp details for assessment rather than using the 22 mm opening as a complete specification.