Ink illustration of the Blancpain Bathyscaphe 5000 1110 B52A watch head, with a meteor-grey dial, dark bezel, red seconds tip, angled date and bare steel lugs.

Watch straps for Blancpain Bathyscaphe 5000 1110 B52A

The steel Bathyscaphe 5000 1110 B52A pairs a meteor-grey dial with a dark diving bezel and a small red seconds-hand accent. Its restrained palette leaves plenty of room to change the strap’s texture. The useful measurement is equally specific: Blancpain publishes 23 mm between the horns.

Reference
5000 1110 B52A
Manufacturer lug gap
23.00 mm

Keep the 23 mm opening exact

Blancpain lists a 43 mm steel case, 13.45 mm thickness and 23.00 mm width between horns for this reference. That last figure is case-opening evidence. It is not a complete replacement specification: end thickness, attachment hardware, clearance and closure dimensions still need checking.

The B52A configuration is shown with a pin buckle. The manufacturer calls the supplied strap type sail-canvas and lists its material as rubber. Keep that description separate from any proposed leather construction. The same 5000 1110 head also appears with other factory strap or clasp suffixes; begin with the complete reference and the hardware actually present.

Colour, construction and fit

Let texture change the neutral palette

Black leather can continue the bezel’s dark outline, while charcoal or taupe creates a softer transition from the grey dial. Brown introduces warmth without needing another bright colour. A smooth surface can look more restrained; a fine grain introduces visible texture beside the brushed steel.

The small red seconds tip is already a distinctive accent. Matching it with red stitching is optional, and a quiet seam can keep attention on the dial. Look at physical samples beside the watch, especially when comparing cool grey leather with warmer grey or brown tones.

Check the ends without rounding the measurement

Do not treat the published 23 mm opening as an instruction to squeeze in a wider strap or leave avoidable side play with a narrower one. Have the actual opening and proposed attachment checked together. The end profile must leave room to move without rubbing or pressing against the case.

A change from the supplied flexible arrangement to leather also changes how the strap bends near the horns. Discuss end thickness and flexibility with the maker rather than assuming a padded profile is preferable for a 43 mm case. The finished illustration identifies the watch; it cannot supply those hidden dimensions.

Specify the closure and useful length together

Decide whether the new strap will use a separately specified buckle or an original component whose suitability has been confirmed. A pin buckle’s appearance or metal colour does not determine its required width, tang dimensions or leather thickness.

Measure wrist circumference and both sides of a comfortable strap, including the usual fastening position. Preserve the original strap and buckle as a complete set if removed. For leather, plan around the material’s stated care and intended exposure; the diving-watch case does not make the strap water-suitable.

Questions about this reference

Is 23 mm a confirmed Da Luca strap specification?

It is the manufacturer’s width between horns. A replacement still needs an exact attachment, end-profile and closure assessment. This guide does not certify a Da Luca installation or prescribe unverified hardware.

Do the other 5000 1110 suffixes mean a different watch head?

The official page groups several factory strap and clasp configurations around the 5000 1110 head. This guide uses B52A as its starting configuration; confirm the full reference and present hardware rather than assuming every suffix uses the same closure.

View Blancpain’s specifications for 5000 1110 B52A